Solidifying lines

Chapter 3: Parameterized typing with generics: P 68, Figure 3.1

Created: 5/21/2008
Last updated: 5/28/2008
Severity: Formatting improvement

In figure 3.1, there are various lines which could be considered to be "dashed lines". Unfortunately I refer to just one set of them on page 69, so it would be better if the others weren't dashed.

The long vertical line splitting the left side from the right should be solid but very thin (or grey). The lines labeled "Instantiation" can be turned into solid lines. This leaves just the lines labeled "Specification of type arguments" as dashed lines.